in the last two years there was no issue to use this values, but for your information if you set it a value of 10 instead of 14 you have the same...
do you driver ever this car? can you explain why this values is stupid !
If the values should not be modified, then it will the best remove it from the car setup or better make fixed setup far all parameter, that nobody...
with engine break reduction of 1 you get the problems of unstable car in slow turns
With the default setup you have not the issue, but the problem is that the default setup is very slow, and you have a cap up to 2 seconds to a...
the issue can be easy reproduced with the default setup, you need only to change the engine break reduction to 1 and set the rear wing to 14 and...
the issue is not only related to Interlgos i have the same issue on Aragon. With the default setup the issue is not visible, but to use default...
Nice facts what was here discussed about the continues acceleration after stop fuel for the engine, and how weather and track condition can...
What was the wear before the update, that we can compare.
For setting the correct camber it was the recommendation to have 10 degrees between inside tyre temperature und outside tyre temperature, but now...
Can one developer comment on this problem
Before last Update there was not this issue, so it is a new bug
If you accelerate hard with the speed limiter that the Wheels will spin, then you excite the speed limit on the pit you get penalty
A Pit limiter should handle this, if you look the most driver despatching the Pit slot with spinning wheels
Hello There is a new bug with the Pit limiter. With normal accelration the limiter is working well, but if you accelerate with spinning wheels...
Separate names with a comma.
