Question Support for the rumble motors on Fanatec ClubSport Pedals

@Sector3: After adding Fanatec V2 support with patch 07-07-2015 (thanks again for that) i would like to ask if also support for the rumble motors on the Fanatec ClubSport Pedals could be added.
The CSP v1 and v2 have 1 rumble motor at the brake pedal and the new CSP v3 have 2 rumble motors (brake and gas pedal).
It would be great to have some vibration feedback on the pedals. (ABS, locking tyres, TCS, etc.)

Thanks in advance.

cheers
Ernie

 

Apologies for thread crapping Ernie, but that's a neat feature. Thanks for mentioning it.

 

You have to connect to the base for FFB

 

Thanks for info. I'll try it.
I had used the CSP v1 for years (connected to USB only because of the higher resolution) and recently got my new CSP v3. AFAIK there's no difference in resolution anymore. 12bit with both connections (direct on base and USB). Now i have my pedals connected directly to my V2 base, but i haven't tried R3E yet. I'll test it this weekend.

Just for info: PCARS supports the rumble motors on the pedals also via USB connection. So technically it should be possible also with USB.

 

Sorry for the obvious question but do you use Fanaleds?

 

I know Fanaleds, but i'm not using it. Can't say why. Maybe to complicated to configure it.

I'd just like to see native support for the CSP in R3E.

 

Yeah, I was sure you were aware of Fanaleds. Getting brake rumble is very easy using it. Just a check box in the UI.

However, I totally agree, native support should be available.